← Back to Portal
SLP Alaska
🔥 HOT WORK PERMIT

Hot Work Permit

SLP Alaska Safety Management System

📋 Permit Information
⚠️ Area Operator Requirements
These items must be verified by the Area Operator/Issuing Authority before hot work begins.
Zero Energy State Achieved?
Flow/Pressure Requirements Met?
Flammable Atmosphere Mitigated?
Fire/Halon/Water Mist Bypassed?
Remote Shutdowns Disabled?
🧪 Gas Testing
Gas testing required before and during hot work. Acceptable levels: O₂: 19.5-23.5%, LEL: <10%, H₂S: <10 ppm, CO: <25 ppm

Test 1 (Initial):

Test 2 (Follow-up):

📝 Special Precautions
✓ Verification of Conditions
Safety Requirements Reviewed for Welding/Cutting?
Work Area Compatible with Hot Work?
Correct Line/Equipment Identified?
Zero Energy State Verified?
Flammables Removed/Protected (35ft)?
Work May Cause Remote Alarm?
Near Halon/Water Mist Discharge?
Continual Gas Monitoring in Place?
Sumps/Drains/Vents Covered?
Spark Containment Adequate?
Purge Required/Reviewed?
Fire Extinguisher Present?
Respiratory Protection Required?
🔥 Fire Watch
Fire watch is required during hot work and for a minimum of 30 minutes after hot work is completed.
⚡ In-Service Welding Requirements
Welding Machine Properly Grounded?
Hoses/Cables Connected Properly?
Gas Cylinders Secured Upright?
Ventilation Adequate?
In-Service Welding Package Required?
UT Report Verified (Min Wall)?
⚠️ Critical Hazard Categories

Check all hazard categories that apply:

Working at Heights
Working Over Water
High Pressure Work
Critical Lifts
Low Temp/High Wind
Manual Handling >50lb
Excavation/Trenching
Other High Hazard
🔧 Hazard Mitigation
TaskHazardMitigation
✍️ Authorization
AnthroSafe™ Field Driven Safety|© 2026 SLP Alaska, LLC